Apparently, this user prefers to keep an air of mystery about them.
Top network posts
- 9 Why do different drivers change the noise of steppers?
- 7 What exactly is the relationship between Flow/Feed Rate and (Print) Speed?
- 7 Switched to a Bowden setup. Should I retract the filament out at the end of a print?
- 7 None of the pins work as inputs
- 6 Hold torque during pause to change filament
- 6 Run code once after programming
- 5 How can I simulate an accelerometer?
- View more network posts →
This user doesn’t have any gold badges yet.
This user doesn’t have any silver badges yet.
Keeping a low profile.
This user hasn't posted yet.